When you have a boat, regardless of its size, you recognize that it is an investment that needs to be protected. Just as you would protect your vehicle by putting it inside of a garage, you would protect your boat by using a boat lift. Not only does it help to protect the boat from the natural elements that may be in the environment, it also helps to protect it from other boats. As long as you care for the electric boat hoist and use it properly, it will provide you with years of quality service. Here is how to use it.
The first thing that you would do is to lower the boat. The lift motor should be powered with the available switch and at that point, the boat will begin dropping down into the water. When the boat is floating in the water, it is time to stop using the power on the lift by flipping the switch. If you are using a cable system, look for any slack in the cables to determine when you should discontinue the power. https://travellifts.com/electric-boat-hoist/
At this point, someone should get into the boat to drive the boat from the area of the lift. Another person should remain at the controls to operate the boat lift if necessary. It is important for you to carefully steer the boat out of the boat lift to avoid any damage. Make sure that you are clear from the lift before re-engaging the power to it.
Now that the boat is outside of the lift in a safe location, you need to protect the boat travel lift from any type of damage. The best way that you can do this is to engage the motor on the boat lift and raise it until it is just above the water’s surface. This provides a number of benefits, including saving it from corrosion and other damage that could occur if it was left underwater. In addition, it keeps other people from either using the boat lift or accidentally running into it under the surface of the water, causing damage.
Now that your boat is safely off the lift, you can enjoy your day out on the water. When the day is done and it is time to put the boat back on the lift, you would basically reverse the directions that were provided above. Here are a few things to consider.
Since you raised the lift out of the water after removing the boat, you need to lower the lift back into the water again. You could lower it until it hits the bottom or until it is low enough that the boat can safely travel onto it. Make sure you disengage the engine of the lift once it is in position.
Repositioning the boat onto the lift is important, because you would not want too much shifting to take place as the lift was being pulled from the water. After the boat is in position, turn on the lift motor and begin raising the boat until it is safely out of the water. Make sure that you don’t raise it so high that the driver can’t exit the boat safely. Finally, you should find a reputable supplier.